Leo Greiner's LBNL Page


For the HFT RDO System, click HERE

For current schematics, click HERE

For latch up tests, click HERE

The Mechanical Prototype Measured Properties shows the status of the mechanical fundamental mode vibration and air cooling induced vibration and displacements as measured on the initial mechanical prototype.

The ir_prelim_writeup.htm shows the status of the air cooling tests done with simple thermal mockups of the expected pixel ladder.

The pixel_rad_length.pdf is a pdf of an initial look at the radiation lengths of the materials we expect to use in the pixel detector.

The pixel_ladder_2.pdf is a pdf of an schedule document that shows our tasks and schedule for producing a prototype ladder assembly and complete mechanical mockups by September 2004.

The sept_proposal.pdf is a pdf of the options for the proposed hardware and electronics system to be produced for the prototype ladder assembly for September 2004.

The cable_constraint.htm shows the current design parameters of the cable for the september test as well as the status.

The SCHEMATIC1_PAGE5.pdf is a pdf of the schematic electronic for a single MIMOSA5 detector and electronics drivers for the September test.

The signal_list.pdf is a pdf of the list of signals expected to be carried on the cable for the September test.

The signal_list_final_cable.pdf is a pdf of the draft list of signals expected to be carried on the final cable.

The nitrogen_purge_document.pdf is a pdf of the description and operating procedure for the nitrogen purge system for the pixel testing box.

The dicing_writeup_1.htm shows the status of the first attempt at thinning and dicing a MIMOSA wafer.

The Pixel_Prototype_Testing.pdf gives the block diagrams and testing plans for the prototype ladder.

The rvc_beam_bend_first_look.mht is a preliminary first look at the bending properties of the RVC / CFC beam.

The film_adhesive_porgress_report.pdf is a preliminary first look at the use of thin film acrylic adhesives for bonding the Silicon to the Kapton cable.

The pressure_chamber_operating_procedure.pdf is gas system schematic and operating procedure for using the pressurization chamber to improve the bonding of the thin film acrylic adhesives used on the carrier.

The crossing_lines_measurement_first_look.htm is a first look at the flatness of a bonded thinned MIMOSA detector using high granularity points from the CMM.

The cable_writeup.htm is report on the performance of the low mass cable designed for use in the ladder prototype.

The thinned_mimosa_testing.htm is report on the first testing of thinned MIMOSA5 detectors using film adhesive as a bonding agent.

The update_radlength_for_proposal_2005_01_13.pdf is a pdf of a short summary update to the radiation lengths of the materials we expect to use in the pixel detector.

The 3_figures.zip is a zip archive of 3 figures on prototype testing for the proposal

The 01-27-2005_lg.zip is a zip archive of the proposal modified by leo for the final submission

The 2005_04_06_ladder_status.htm is a report on the current status of the construction and testing of the prototype ladder

The MIMOSA5_status_and_location.htm is a report on the current status and location of the MIMOSA5 detectors that we have received.

The js_ddl_talk.htm is a page with Jo's PPT presentation and relevant links to his talk on the CERN DDL as used in the STAR TOF.

The readout_draft.htm is a draft of our proposed electronics/DAQ model for the HFT.

The lg_nsd_ann_report_2005_06_20.pdf is the contribution to the 2004 NSD annual report.

The thinning_procedure.htm describes the thinning procedure used for testing the efects of thinning on the MIMOSA5 detectors.

The bt2005_writeup.htm is description of the ALS area for the 2005 beam test and a list of tasks.

The update_radlength_for_proposal_2005_11_17.pdf is a pdf of a short summary update to the radiation lengths of the materials we expect to use in the HFT for the November 2005 proposal.

The rates_HFT_after_reduction.pdf is description of the data rates coming out of the HFT.

The data_reduction.pdf is description of a cluster finding FPGA algorithm for the HFT.

The daq_chapter_hft_2005_11_22.pdf is a pdf of the DAQ chapter for the HFT proposal as of November 2, 2005.

The data_reduction_3.pdf is an updated description of a more advanced cluster finding FPGA algorithm for the HFT.

The ReadoutConcept.pdf is Howard Wieman's conceptual readout design for the HFT.

The LG_HFT_BNL_DAC_03_15_2006_2.ppt is the ppt file for the HFT readout and hardware prototyping progress given to the BNL DAC.

The Readout_for_HFT_at_STAR_2.ppt is the ppt file for the HFT readout scheme given at the STAR upgrades workshop in December 2005.

The proposed_hardware_installation.pdf is a writeup on the hardware we expect to install into the STAR detector for prototype testing in summer 2006.

The mimostar2oddities.pdf is a writeup on some MIMOSTAR2 testing results with some questions about some of the observed behavior.

The Sept_2006_system.doc is a writeup describing a first pass at the hardware, software and firmware required for the September 2006 HFT test.

The RDO_section_HFT_proposal.pdf is a pdf of the DAQ chapter for the HFT proposal as of June 19, 2006.

The sept_test_description.pdf is a document describing the goals and hardware for the September 2006 HFT test detector.

The task_list_august_2006.pdf is a document giving a task list for the August 2006 HFT prototype test installtion at BNL.

The lg_nsd_ann_report_2006_07_29.pdf is the contribution to the 2005 NSD annual report.

The AA9280000 - PDF.pdf is the MSDS for Hysol EA9396 Adhesive Part A.

The AB9280000 - PDF.pdf is the MSDS for Hysol EA9396 Adhesive Part B.

The infrastructure_test_2006_10_29.pdf is a material and task list for the infrastructure testing at BNL in preparation for the telecope test.

The ladder_thermal_imaging.pdf is an update to the initial air cooling tests using a much more realistic ladder model.

The presentation_to_ires_2007_01_19.pdf is a short description of our test MIMOSTAR2 telescope withgoals and status.

The hft_telescope_setup_ver02.ppt is a powerpoint presentation of testing plans and status to be presented on the January 19, 2006 video conference .

The LG_HFT_rate_calculation_2007_02_02.pdf is description of the data rates coming out of the HFT for 33 ladders @ 4.5 cm radius.

The Requirements_HFT.doc is a short description of the mechanical structure requirements for the HFT.

The StrasbourgTrip_summary.pdf is Marc Winter's short summary of the LBNL / IPHC meeting held in Strasbourgh in Jsnuary 2006.

The ultimate_parameters_readout.pdf is document proposing a set of parameters and a readout scheme for the ultimate sensor for the HFT.

The hft-06-08-2006_lg.doc is the modified proposal with an updated Ch5. Readout section for the HFT. (2007-03-20)